SERVOGEAR | 70% Kinetic Energy Reduction
Using DESMA ServoGear drive system, kinetic energy can be reduced by up to 70% in a typical rubber injection molding process.
Some additional advantages of this system at a glance:
– The savings of the electric drive are up to 45% when considering cycle times of approximately 4 minutes.
– Optimum energy savings are achieved by reducing pump speed to zero during functional breaks of the hydraulic system (e.g., during cure time)
– Two (2) pumps per axis allow for adjusting the flow rate and load of the motor and servo converter via three-gear stages to minimize power demand peaks.
– Significant reduction in noise resulting in sound emission comparable to all-electric machines.
– Reduced oil cooling requirements as there are no load losses.
– Perfect functional quality and precision thanks to the use of the appropriate pump (1st, 2nd, or 3rd gear).
– Less influence of oil temperature on positioning accuracy.
Back to News